TraSys® Pioneering Water-Based Technology for the Rotational Molding Industry
Benefits
Stoner Coating & Release Systems supply the plastic rotational molding industry with the best in water-based mold release coatings. Free of alcohol and solvents, these coatings meet all existing and anticipated environmental regulations. Stoner coatings yield consistent, controlled release for maximum performance.
Rotational molders use Stoner release coatings because:
- Their long life can reduce the need for frequent operator spraying
- They are safe, easy to use, and work with LLDPE, LDPE, MDPE, HDPE, LXPE, PP, plastisol, and nylon
- They exhibit minimal transfer of release materials to the molded product
- They produce consistent parts without warpage or sticking, allowing your production to run smoothly
- Stoner provides qualified, expert technical support
| |
TraSys® 420 |
TraSys® 414 |
TraSys® 500 |
TraSys® 715 |
| Release Type |
Semi-Permanent, General-Purpose |
Semi-Permanent, High Release |
Semi-Permanent, General-Purpose |
Semi-Permanent, Light Release |
| Resin Carrier |
Water |
Water |
Water |
Water |
| Typical Uses |
Mold Internals |
Part Lines, Removable Pins, High Releases |
Mold Internals, Open Flame |
Large Flat Surfaces, Difficulty in Containing Warpage |
| Solvent Free |
Yes |
Yes |
Yes |
Yes |
| Alcohol Free |
Yes |
Yes |
Yes |
Yes |
| Recomm. Compat. Compounds |
LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols |
LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols |
LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols |
LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols |
| Apply to Mold |
Warm2 |
Warm2 |
Warm2 |
Warm2 |
Min. Cure Temp. /
Min. Cure Time |
132°C (270°F)3 /
5 minutes |
132°C (270°F)3 /
5 minutes |
132°C (270°F)3 /
5 minutes |
132°C (270°F)3 /
5 minutes |
| Agitation Required |
Slight |
Slight |
Slight |
Slight |
| Product Cosmetics |
Satin |
Satin |
Satin |
Satin |
| Appl. Frequency |
Varies with Function |
Varies with Function |
Varies with Function |
Varies with Function |
| Action if Frozen |
Thaw, Agitate |
Thaw, Agitate |
Thaw, Agitate |
Thaw, Agitate |
- Non-ozone depleting, noncarcinogenic solvent, No VOC content.
- Hot to the touch; approximately 48°-60°C (120°-140°F).
- Inner mold temperature; normally accomplished by cycling coated mold when empty.
- Air cures rapidly on substrates at 32°-38°C (70°-100°F). Introduction of 149°C (300°F) heat after application enhances cure and prolongs durability of coating.
|
